Feb 19, 2023 · If you have recently replaced a wheel bearing on your vehicle, you may need to reset the ABS light.

Some are shared between the two and some are not.

This is because the ABS sensor may have been. If the ABS and Traction Control light came on after you got your car serviced, something may have gone wrong during your brake job.

Originally Posted by 2008_335i_coupe.

.

We recently had lights come on for the abs and traction control. . Nissan Altima.

The sensor can become damaged, worn, or corroded due to.

. . I thought it was abs sensor and replaced and it is still on.

You never know without going through the procedures outlined in the manual. Toyota Rear Wheel Bearing with ABS Sensor.

.

The change went well, while I had everything off I went ahead and replaced the brake pads.

I had the drivers side rear wheel bearing replaced and now the ABS warning light is on. $94.

The sensor connector wires were not reconnected to their original position. ABS light: Low battery voltage (computer not getting enough voltage) Broken wheel speed sensor wire; Bad wheel bearing; Dirty tone ring; Bad ABS module; BRAKE light: Low brake fluid; Low brake pads; Parking brake set.

4.
.
.

.

.

. . Car Repair Resources.

So I disconnected the battery and waited 30 mins, lights still on. . Change the ABS sensor that controls your anti-lock brakes. 99 - $114. make sure front brake.

In order to fix this issue, the ABS sensor needs to be properly reattached, and the ABS system needs to be.

This can be done by disconnecting the negative cable from the battery for a minimum of 15 minutes. The problem comes if there is no way to replace or buy just the ABS ring.

Get a Quote.

Apr 9, 2023 · An ABS light on your car’s dashboard means there is an issue with the car’s anti-lock braking system.

place wood on axle shaft and knock it in.

This is a video tutorial on the top 3 most common things to check when an ABS light comes on.

No issues found with a Blue Driver dongle.